Hey first time poster.... long time reader!
I'v been reading on emission testing and q&a on getting 1.3 carbed to pass.
this is what I got. SORRY FOR LONG POST
My sammy has alway done well blown clean test, i've owned it for 4 years, rebuilt from the inside out,remanufactored carb haven't even put more than 8k road mile on it in 4 years. changed the plugs, trimmed and checked vacumm lines for leaks,changed the oil.
no smoke, runs like a top

It's always passed on the dyno until now.they tried it again on the 2 speed idle
my HC was off the page!!!!

this is what it read:
                       high speed                                         low speed
                    std         current                                       std     current
HC               220         4094!!!          fail                        220     706 !!   fail
co                1.2          .48            pass                           1.2      .21     pass
co2                              .92                                                         11.
o2                                7.3                                                         5.1
dillution     >6.0            9.64           pass                      >6.         11.19  pass

now, i've been reading a few fixes,
1- carb too lean. ok.i found the screw which way do i adjust it? counter or clock wise-       how far
2- oil- changed the old\filter- for the first time i used mobil 5-40 blend, i've always used castrol 10-40 before-  is it the oil?   
THANKS FOR ANY HELP GUYS~