ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: blyota91 on March 08, 2005, 09:10:58 AM

Title: Winch mounting
Post by: blyota91 on March 08, 2005, 09:10:58 AM

I want to build some sort of front winch bumper for my samurai.  How thick of steel do I need to make it hold up to a decent sized winch?  I have some 3/16" thick angle iron, could I make frame extensions and have this be strong enough?

Title: Re: Winch mounting
Post by: tracker8wr on March 08, 2005, 12:25:07 PM

r u just going to use the angle to extend the fram and then box it in for a winch box. if so what r the rest of the dimensions of the angle iron.

Title: Re: Winch mounting
Post by: tracker8wr on March 08, 2005, 12:31:12 PM

check out My New Front Bumper it is a really simple bumper and well made.

Title: Re: Winch mounting
Post by: prairie_dog on March 08, 2005, 03:18:35 PM

 I would make the winch mount plate and frame ext. with the 3/16 then fab the rest with 1/8 or 10 gauge. Built a front bumper for my last tracker out of 3/16 ( looked like the calmini one, tough as nails and weighted as much as the engine) If you build it to strong and hit something usually the frame bends first ( big bucks repair )

Hope that helps some :) :)

Title: Re: Winch mounting
Post by: blyota91 on March 08, 2005, 10:19:53 PM

The angle iron is 3X3  I would probably box it in and weld it all together.  Should I bolt the extensions to the frame or weld it?