ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum
ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: ack on July 03, 2006, 05:39:17 PM
-
I have finally given in and want to install the 1.5" Digger spacer lift on the Tracker 4-door so I don't have to drive it bone-stock at the Melt.
However...
If it won't lift the truck enough to run the 30" BFG A/Ts, I won't do it... I was going to do the mod at the campground and if it won't work, I might as well leave the tires at home (Kansas City). It'll look "festive" on stock tires, but I'll at least get some body damage protection from the lift...
So, can I run my 30's after this lift? ???
Leaving in 35 hours...
-
i'd say yes. at least with my recent 1.5" spacer lift on my two door i'm positive i can put 30's under there now. i'm going to post some pics here shortly.
mike
-
i'llsay yes .. i've got them in my four door,, should get two or two an a halfs for the back. just to give it that little bit of rake.. mine's a little nose high with just the 1.5's on all corners.. you might want to do them bofor you go though. cuz you'll need a wheel alignment quite badly.. camber bolts and reset the tow...
-
they 'should' fit ok, they will likely rub the frame when turning but not bad with AT grips. i have the same setup on my 2003 2dr with no problems at all.
-
235/75R15's fit stock so 30x9.5R15's will fit stock as well. They'll rub the frame a teensy bit more but with that lift that would still be the only "rubbage."
-
Excellent!
I'll be running them on the Bronco Wagonwheels off my Samurai.
At least I'll be able to run the dunes and the mild trails...
Thanks!
-
A friend of mine has 30x9.5's on his stock sidekick, using stock rims, minimal rub.
I have 1.75" of lift using spacers, I have 30x9.5's on mine using 15x7" wheels, mine rubbed on the pinch weld a little bit, and the inner, lower corner of the fender, but I fixed that with an angle grinder and a hammer.
-
Hey Ack, good luck with the install and get some before and after pics, we love pics! LOL! 8)