ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: Jimiweld on August 12, 2006, 06:17:22 PM

Title: What all is Needed to Change my 8v to a 16v engine?
Post by: Jimiweld on August 12, 2006, 06:17:22 PM

What all will I need to do this in my tracker. I will need the computer, but will I need the wiring harness, rad, hoses etc as well? Or do all of these just plug into the 8 valve?
Thanks
Jim

Title: Re: What all is Needed to Change my 8v to a 16v engine?
Post by: CJ11 on August 12, 2006, 10:58:15 PM

What you need to do is find a 16V kick in good shape and swap the bulk of your good parts on it.. That will be the easiest way to go.

Title: Re: What all is Needed to Change my 8v to a 16v engine?
Post by: Jimiweld on August 13, 2006, 06:09:15 AM

Really, that much work then eh. I'll probably just replace mine with another 8v when it dies then. It's ok for now, but if a 16v was an easy swap I thought I'd start looking for the bits and pieces now to prepare for it.
Thanks

Title: Re: What all is Needed to Change my 8v to a 16v engine?
Post by: wezzlegod on August 13, 2006, 09:23:28 AM

you have to replace the computer wire harness for the moter it should clip into your truck existing routing  and spliceing points. and moter with all the exesories(m.a.f.air intake ect). go to the action and get a wrecked one. its not that diffacult of swap a few weekends about 10 hours.