ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: 36zuk on January 23, 2005, 02:19:45 PM

Title: Driveshaft clearence
Post by: 36zuk on January 23, 2005, 02:19:45 PM
I have the RRO trailblazer kit with 3in springs. My driveshaft is hiting my Transmission xmember how can i get that clearence.
Title: Re: Driveshaft clearence
Post by: mudfkr on January 23, 2005, 04:09:38 PM
My mates running that same kit in his "90 Sammy and he had to cut the x- member up a bit, not tidy but it works  :-/.
Title: Re: Driveshaft clearence
Post by: nitromax on January 24, 2005, 02:54:24 AM
Not too much help here, not what I've seen somewhere else  :-X :-X ::) ;D
Title: Re: Driveshaft clearence
Post by: track_this on January 24, 2005, 07:39:04 PM
i think rock4xfabrication.com has a high clearance front crossmember if i recall correctly.

shane
Title: Re: Driveshaft clearence
Post by: rockrat on January 28, 2005, 03:02:10 PM
Yep we do.. replaces the stock x-member completely. 100% bolt in and allows you to cut the stock x-member out and ours goes up and over the driveshaft allowing as much droop as your shaft can physicaly go.
Title: Re: Driveshaft clearence
Post by: HotRod on January 28, 2005, 03:43:11 PM
Is it wide enough to fit a SideKick with a Sammie T-case?