ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: AJMBLAZER on September 02, 2006, 06:24:54 PM

Title: How do you take the body clading off of a Tracker?
Post by: AJMBLAZER on September 02, 2006, 06:24:54 PM

I'm talking about the anti-door ding trim stuff about half way up the doors and fenders at the body line on the mid-90's models.  Seen here:
(http://memimage.cardomain.net/member_images/2/web/2186000-2186999/2186576_20_full.jpg)

With any luck I'll be Chassis Saver'ing the rust and then Herculining at least up to the body line and anywhere else I have rust soon.

These held on by 3M tape?

Title: Re: How do you take the body clading off of a Tracker?
Post by: HotRod on September 02, 2006, 06:31:20 PM

heat and peel.
I'd wait for Sunny day tho. ;D

Title: Re: How do you take the body clading off of a Tracker?
Post by: AJMBLAZER on September 02, 2006, 07:11:32 PM

Like the next week? :P

Heat gun type heat or would a hair dryer work?

Title: Re: How do you take the body clading off of a Tracker?
Post by: Carnage on September 02, 2006, 07:15:47 PM

I just used the Hawaiian Sun and a razorblade on mine

cleaned up the gum with paint thinner

(didnt worry too much as I was going to be painting it anyway)

least there were no holes to plug

(http://memimage.cardomain.net/member_images/1/web/673000-673999/673055_332_full.jpg)

Title: Re: How do you take the body clading off of a Tracker?
Post by: AJMBLAZER on September 02, 2006, 07:33:57 PM

Eh, as long as the crap left over isn't too thick or noticeable I'll probably just clean as much of it off with Xylol as possible and then Herculine over it. 8)