ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: 95tracker on October 13, 2006, 08:38:42 PM

Title: Front bearings
Post by: 95tracker on October 13, 2006, 08:38:42 PM

I am new here i been reading the forums and stuff for about a week and i have a question on my tracker. its a 95 tracker 4x. i am replacing the struts and wheel bearings well i got my hub apart and off the truck but i cannot find the tool to get the bearing nut off. and i have no welder or anything to just fab one up. i have tried to use just a hammer and a punch but i can't get it to budge. i have soaked it with pb blaster and let it set for about 20 min while i went to the parts store but it didn't help anyone got any ideas?

Title: Re: Front bearings
Post by: Skyhiranger on October 16, 2006, 05:22:35 PM

parts stores should have the socket that you need (maybe not all stores, but you should be able to find one at one of them).  don't forget to remove the little phillps head screws, before you try to remove the nut.

Title: Re: Front bearings
Post by: 95tracker on October 20, 2006, 08:54:15 PM

i finally got the stupid thing done, it was a pain. we had to heat the spindle nut with a torch till it was cherry red and then hit it with an air hammer w/ a punch on it cause nobody in town could get the tool that's alright i had already made my own tool for next time.