ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: museboy07 on February 07, 2007, 01:12:46 PM

Title: coil spacers center hole bore
Post by: museboy07 on February 07, 2007, 01:12:46 PM

i just bought some jeep tj coil spacers for my 94 track and i need to know the size to bore the center hole out to....the current hole is 2 1/8" in diamater

Title: Re: coil spacers center hole bore
Post by: TysonS on February 07, 2007, 04:47:30 PM

2.5" im about 95% sure on that

Title: Re: coil spacers center hole bore
Post by: museboy07 on February 07, 2007, 06:40:50 PM

ok thankyou...but this coil spacer has a lip which seems that it would sit down into the coil to keep it in place...if i bore it out to 2.5 in then it will no longer be there...is that lip absolutely needed?

Title: Re: coil spacers center hole bore
Post by: Digger on February 07, 2007, 08:02:48 PM

Check out this thread:

http://www.zukiworld.com/forum/index.php?topic=7930.0

Title: Re: coil spacers center hole bore
Post by: museboy07 on February 07, 2007, 09:44:10 PM

im goin to drill the center to 2.5in so should that be enough? on the one side of the spacer there is a cone shape drill down in bout 1/2" im guessing this is where it will sit on the coil cup?

Title: Re: coil spacers center hole bore
Post by: PHX96TRACK on February 10, 2007, 08:42:30 PM

I did mine today 2.5 is right. My daystar 1-3/4" jeep spacers didn't fit in front I had to bore them out. They did fit fine in back tightly... I need a drill bit to finish the rear shock mounts. I'll be done tomorrow if I can figure out the camber situation.