ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: museboy07 on May 30, 2007, 06:20:44 PM

Title: stronger cv's
Post by: museboy07 on May 30, 2007, 06:20:44 PM

I'm lookin for a stronger cv shaft/joints that can be used at a higher angle.  I want as much ground clearance as i can get without dropping the diff or swapping over to a solid axle.  Any help/links of this would be great...thanks!

Title: Re: stronger cv's
Post by: crikeymike on May 30, 2007, 09:17:13 PM

Now that's a tough list of requirements.  The best bet is to probably use something similar to the calmini anvil so you can use 2 x driver side cv shafts instead of the passenger...

The other option is toyota cv's, but i don't really know much about that.

Title: Re: stronger cv's
Post by: MKOLSEN22 on May 30, 2007, 09:20:55 PM

Talk with your local machinist/sandrail builder and figure out how to run some 930 or 934 CV's!!  This has been talked about from time to time but I don't think I have ever seen it done yet.  If it has been done I haven't seen the write up for it.

Not saying that it hasn't been done, I just haven't seen it yet.

Start the chant.  

Do it!  Do it!!  Do it!!!  Do it!!!!  Do it!!!!!  Do it!!!!!!