ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: calabrias1962 on June 08, 2007, 08:29:11 PM

Title: Transfercase arms
Post by: calabrias1962 on June 08, 2007, 08:29:11 PM

Does anyone have any pic's of how they reinforced their long and short
arms?
Thanks

Title: Re: Transfercase arms
Post by: Drone637 on June 09, 2007, 02:18:57 AM

No picture, but I just welded a piece of angle iron on the inside of the long arm.  Haven't had any problems with it bending.

Title: Re: Transfercase arms
Post by: calabrias1962 on June 09, 2007, 05:01:27 AM

Quote from: Drone637 on June 09, 2007, 02:18:57 AM

No picture, but I just welded a piece of angle iron on the inside of the long arm.  Haven't had any problems with it bending.

Did you lay it in the same as the arm or did you put it so it made it boxed?
Hope this makes sence.
Thanks

Title: Re: Transfercase arms
Post by: mrfuelish on June 09, 2007, 10:41:55 PM

boxed would be better,on the small arm get some round stock and bend it around the corners and weld it good, and the long arm on the frame clean the inside of the long arm and weld it to the frame, it only comes with the out side welded and will tear off of the frame if you wheel it.