ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: 87Sam87 on June 26, 2007, 09:49:11 AM

Title: Inner wheel bearing question
Post by: 87Sam87 on June 26, 2007, 09:49:11 AM

  I am rebuilding my front end and had a question about the inner wheel bearing seal. How far down do I need to press the inner bearing seal? Do I just make it flush with the edge of the housing or should I press it tight up against the bearing to hold the bearing tightly?

Title: Re: Inner wheel bearing question
Post by: kingzoo on June 29, 2007, 04:20:00 PM

   Flush it up and things will be fine.it will seal properly and work like it should.