ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum
ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: codyhebdon on September 15, 2007, 06:05:20 PM
-
the bolts on my dust guards (cover the brakes in the rear) have rattled loose and i dont know what size or thread pitch they are, anybody know for sure????
-
I took a look in the shop manual and it does not say I am afraid. Hopefully someone else can help you out.
-
Well, what type of zuk you got? (at least I hope its a zuk)
-
1987 suzuki samurai
-
Give Hawk Suzuki a call. They can probably either tell you are send you a couple in the mail. :)
-
the dust covers are held on by 10 mm socket head bolt. 90% of the bolts on zuks are 10mm. Not too familiar with metric bolts but the thread gauge reads 1.00 mm with a 5mm dia. Just take a 10 mm bolt off of another part and try to thread it on if you want to be sure.
-
Huh, mine where held on by little phillips screws... But they were on a 410 and not a Sammy.
-
the dust covers are held on by 10 mm socket head bolt. 90% of the bolts on zuks are 10mm. Not too familiar with metric bolts but the thread gauge reads 1.00 mm with a 5mm dia. Just take a 10 mm bolt off of another part and try to thread it on if you want to be sure.
If its a a 10mm head then it will be a M6x 1.0 bolt.
-
yes these are little phillips head screws..thanks for the help, but hawk suzuki is sending me 6 new ones so i dont need to find the size anymore. thanks for the help though.
cody
-
If its a a 10mm head then it will be a M6x 1.0 bolt.
[/quote]
Yeah your right, I guess M6 is the dia.(6mm) and 1.0 the pitch