ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: ultra-rebel on February 13, 2008, 07:54:23 AM

Title: Rear Diff Question
Post by: ultra-rebel on February 13, 2008, 07:54:23 AM

I pulled the rear diff to weld er up and it looks like a limited slip diff. There are no visible side gears like other diffs I have taken apart and I dont want to disassemble if I dont have to.

Can someone tell me if this is in fact a LS or do I have to pull it apart to get at and weld the gears

Title: Re: Rear Diff Question
Post by: Mikerpm4x4 on February 13, 2008, 10:39:16 AM

This is a standard diff. I can see the side gears in the photos. The spiders are webbed which is why it looks funny to you. I wouldnt dissasemble the diff to weld it. I just weld what I can see in the windows and call it good. Its always worked for me.

Title: Re: Rear Diff Question
Post by: ultra-rebel on February 13, 2008, 12:14:08 PM

Thanks Mike I'll try welding it through the windows this weekend.
Rebel

Title: Re: Rear Diff Question
Post by: ultra-rebel on February 21, 2008, 10:26:41 PM

I welded er up and she works fine so far......  Thanks guys

Title: Re: Rear Diff Question
Post by: big_kountry21 on February 21, 2008, 11:00:28 PM

was it hard to weld?

Title: Re: Rear Diff Question
Post by: ultra-rebel on February 22, 2008, 07:08:59 AM

No,  after removing the diff there are four 1" windows.  I just cranked up the old Lincoln and welded the dff through the windows.
I did however find that welded diffs on ice are very scary on these little trucks. I dont think I would do it on my DD