ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: Crabzuki on October 13, 2004, 12:19:18 PM

Title: Dialing in Dual 40MM Webbers
Post by: Crabzuki on October 13, 2004, 12:19:18 PM

I have seen a link some where on this site for tuning the carbs but can't find it. Anyway is there some place I can get a tool to get these dialed in correctly? Eric, Jason, Chunk anybody know where? - CZ

I had them running correctly until an A$$HOLE played with it during a tune-up which was to consist of plugs, wires, new rotor cap, and timing checked.

Title: Re: Dialing in Dual 40MM Webbers
Post by: wildgoody on October 13, 2004, 05:08:10 PM

Just sync the vacuume at idle,
same reading Hg  then adjust
the idle mixture if it needs it

I played with a Dual Quad
setup on a 57 Cadillac, I spent
hours jacking with it, until I
remembered to sync the vacuume,
once I did that, it would idle fine

Wild

Title: Re: Dialing in Dual 40MM Webbers
Post by: ebewley on October 14, 2004, 02:03:18 AM

Quote

I have seen a link some where on this site for tuning the carbs but can't find it. Anyway is there some place I can get a tool to get these dialed in correctly? Eric, Jason, Chunk anybody know where? - CZ

I had them running correctly until an A$$HOLE played with it during a tune-up which was to consist of plugs, wires, new rotor cap, and timing checked.

Hey CZ,

The article is in the Archive. Here's the link:

http://www.zukiworld.com/month_050102/feature_dcoesetup.htm

Good Luck, -Eric