ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Build Diaries, How-To, DIY => Topic started by: dustybadlands on June 07, 2008, 09:34:29 PM

Title: Dustybadland's DIY front wheel bearing nut tool:
Post by: dustybadlands on June 07, 2008, 09:34:29 PM

(http://i298.photobucket.com/albums/mm248/dustybadlands/fabs/DSC01935.jpg)

Title: Re: Dustybadland's DIY front wheel bearing nut tool:
Post by: dustybadlands on June 07, 2008, 09:53:33 PM

This took me two tries to get right. the pics show a 1/4 bolt, I settled on a 3/8 and just ground the shoulder down on a bench grinder after I cut the head off. The length of 2X2-1/8 wall  square stock I extended to 2 inches. Use a bearing nut as a welding jig for depth and spacing.
(http://i298.photobucket.com/albums/mm248/dustybadlands/fabs/DSC01932.jpg)
(http://i298.photobucket.com/albums/mm248/dustybadlands/fabs/DSC01933.jpg)
(http://i298.photobucket.com/albums/mm248/dustybadlands/fabs/DSC01934.jpg)
  If I make another I might even use 4 pins. If there was interest, Id consider fab'n some up to sell.