ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: ppltrak on August 22, 2008, 01:29:12 PM

Title: T-case rear output bearing???
Post by: ppltrak on August 22, 2008, 01:29:12 PM

I need to replace the output bearing on a 93 kick. The yoke and bearing have gave up the ghost. Can I just remove the back part of the T-case and press out the bearing, then do the opposite to install? Or do I have to remove the whole case and split it on the bench. Any help would be great.

    Thanks
     Kevin

Title: Re: T-case rear output bearing???
Post by: RHodge on August 22, 2008, 02:09:43 PM

I've always found it easer to take something out rather then laying on my back trying to fix it.


Ryan 

Title: Re: T-case rear output bearing???
Post by: ppltrak on August 22, 2008, 02:10:50 PM

I have a lift ;)

  Kevin

Title: Re: T-case rear output bearing???
Post by: J-Ron on August 22, 2008, 09:33:07 PM

I recently did the 6.5 : 1 t-case gears and i believe the rear output bearing is impossible to get out without dropping the entire t-case. cause the output assembly has a snap ring holding it together and i needed a hydraulic press to get the bearings off.

here's a pretty good illustration http://trail-gear.com/tech/zuk65gears/index.html

Title: Re: T-case rear output bearing???
Post by: mrfuelish on August 22, 2008, 10:06:37 PM

I think he is talking about a tracker t case, it has a needle bearing that has to be pulled from the back.

Title: Re: T-case rear output bearing???
Post by: J-Ron on August 23, 2008, 11:51:22 AM

well it's all greek to me then....