ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: bashzuk on January 30, 2009, 10:27:32 PM

Title: Sidekick drive line flange does this mate to the toyota axle flange?
Post by: bashzuk on January 30, 2009, 10:27:32 PM

I've been told that this mates right up. Is this true?

Title: Re: Sidekick drive line flange does this mate to the toyota axle flange?
Post by: bashzuk on February 06, 2009, 08:28:00 PM

No one knows if this is true

Title: Re: Sidekick drive line flange does this mate to the toyota axle flange?
Post by: Drone637 on February 06, 2009, 10:36:37 PM

Supposedly.   I have also read that you need to modify the drive line as well, getting rid of the lip, so the only thing holding it in place is the bolts. Low Range Off-Road has adaptors for 25 dollars a piece at http://www.lowrangeoffroad.com/samyotaswap.htm and is probably the easiest.  Did you find a set of Toy axles?

Another article I found mentioned that the transfercase side flange of the post 85 Toyota front drive shafts will bolt up to the large flange Tracker transfer cases.  Haven't seen confirmation on that though.

Title: Re: Sidekick drive line flange does this mate to the toyota axle flange?
Post by: bashzuk on February 09, 2009, 03:55:31 PM

Yeah I have a set laying around and I'm trying to figure out if I'm going to use them or not.

Title: Re: Sidekick drive line flange does this mate to the toyota axle flange?
Post by: biker on February 09, 2009, 09:01:26 PM

If you mean Sidekick driveshaft to Toy axle then the answer is not really. It will fit into the aligning hole in the center but only 2 bolts will line up, this is on an early Toy axle and I think the later ones have a bigger bolt pattern.