ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum
ZUKIWORLD Discussion Forum => Technical Discussion - Beginner / Repair => Topic started by: elprincipal on October 21, 2009, 07:51:36 PM
-
I AM LOOKING AT COATING MY FLOORBOARDS WITH RHINO COAT OR SOMETHING SIMILAR ON 88 SAMMY. ANY SUGGESTIONS OR IDEAS ??
-
Clean it well and use a heat gun to remove the sticky
sound deadening stuff, it's a pain but doable, then
spray it with a gun, don't use spray cans, not thick enough
and the cost is high
Wild
-
I used herculiner (sp?), and then put on two coats of enamel to fill the crevices. I was not impressed with the liner, it holds mud and dirt like mad. I have also wore through the liner where my heel rests. It is nice to just pull the plug and wash it out. When I was running in the snow and mud, I just left the plugs out. Didn't seem to pick up much from the underside, just from my boots,
-
I used herculiner (sp?), and then put on two coats of enamel to fill the crevices. I was not impressed with the liner, it holds mud and dirt like mad. I have also wore through the liner where my heel rests. It is nice to just pull the plug and wash it out. When I was running in the snow and mud, I just left the plugs out. Didn't seem to pick up much from the underside, just from my boots,
Sounds like we might be better off with a bare steel floor and some floor mats or something. I guess it all depends on how muddy you plan on getting. ;D
When I did some rust repair.....I took the carpet out and cleaned it...patched up the floor and painted it, then put my carpet back in. I like my carpet just fine. It doesnt hold water because I have the plugs out, and I can just take the carpet out to clean it if it gets too dirty for my liking.