ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum
ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: ColtonP on April 12, 2010, 06:01:01 AM
-
I need to make a body lift not two inches or 3 inches just and inch and a half is all i need to clear my 31s at full flex i have 2 inch coil spacer that work GREAT but after i switched from 235s to 31s im cutting up tread on my rear fenders i dont want to cut my fenders i just want to move my body away from my tires lol some one please help. will i have to extend anything to make 1.5 inch lift??? what all would i need be very specific plz
-
Because of the body studs, I think you are going to have to
just do a 2" lift, sorry, an extra half inch shouldn't cause too
much trouble
Wild
-
take a look at the bushing arrangement at the body mounts.
i put a thin one on the bottom and shimmed in top. gained 1 1/8".
i used some old conveyor belt material- looks similar to tire sidewall or something like that.
still had to do some hammering to the rear of the front well and cut/bend to fit.
rear was some curling of that outer edge. curl up inside- no change form original line- my tires clear well enough.
i have pic i could post later.
even stacked some shim on the frames for those non bolted ones, lowered body down on 'em. haven't lost 'em yet.
works for me- cheap and functional.
also, i had to lower the front drive side brakeline mount in the fender. just slotted well, lower that mount/clip, rivit. done without removing brake line.
-
this uses the stock mounting bolt
(http://i301.photobucket.com/albums/nn56/rascott_2008/PB280159.jpg)
i measured 1 1/8" body lift.
-
well either use 2"HSS duel bolt style or buy sky manufacturing 2" body lift either way u must extend shifters