ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum
ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: igaug on June 07, 2010, 03:28:30 PM
-
im trying to get the old bushings out of my yj springs and am having some trouble. the smaller end i was able to pound out with a hammer, but the larger end with the metal sleeve over the bushings is not budging on any of the 4 springs. all four came out of the others though. anyone have any advice? also im in the process of turning the center spring alignment pin around and one is toast, anyone know where i can get another one? thanks guys
-
I will tell you what I done somebody else may have a better suggestion I took a small drill bit and drilled all the way around the steel bushing into the rubber .This will loosen it up enough that it should come out with a little help with a hammer then and a screwdriver.