ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum
ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: Rhinoman on July 01, 2004, 12:12:47 AM
-
I've read the article again but just want to confirm one point. When you do the front end widening do you only redrill the one mounting point?
-
Yes, that is correct. You move the rear mounting poing out pushing the wheel out and forward. My frame was bashed and bent so much from wheeling that I had to redrill one of the front holes but I had bent it BAD. The other side slid (unbent) right into place.
Zig
-
I did this mod to mine also and am loving it. ;D I now run 32x11.5 tires with lots of room left. Hmmm maybe it's time for some bigger rubber. ::)
-
Well I just noticed my 33s are rubbing a bit :( Obviously didn't cut back the footwells far enough but I think if I did the throttle wouldn't go all the way down anyway. Time to get the drill out I think. This should give me room for longer driveshafts too :) though if I recall the driveshafts point backwards a bit (maybe mine is bent too) so they might end of shorter if I move the wheel forward. How are your bushes holding up they must be pushed a bit out of shape?
-
I was worried about that when I did mine, but it does not bind them up like what you would think ;) There are also alot of guys in Mikes club that has run this set up for a long time with no problems. Drill Away 8)
Zig
-
whre do u drill the holes.
-
whre do u drill the holes.
http://www.zukiworld.com/month_120102/feature_hagan_frontendmod.htm