ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Technical Discussion - Beginner / Repair => Topic started by: jow003 on September 22, 2010, 07:33:03 am

Title: Drive Shaft
Post by: jow003 on September 22, 2010, 07:33:03 am

Im finally finishing my T-case Bulls...  and im not sure about the driveshaft.  I know "the dots have to line up" but does as long as they are does anything else matter? 

Other than the correct one in front/back :P

Title: Re: Drive Shaft
Post by: Drone637 on September 22, 2010, 01:57:43 pm

That should do it!

Title: Re: Drive Shaft
Post by: jow003 on September 22, 2010, 02:18:44 pm

wish i had taken a picture of it but on one side it has a triangle of dots like this, does that mean the other side's dot has to be within those or even with the back one?

Dont get dirty with it  :P

Title: Re: Drive Shaft
Post by: Skyhiranger on September 22, 2010, 06:03:15 pm

You should be looking for single dots.  There are no "triangle of dots" put on either part of the shaft from the factory.

Title: Re: Drive Shaft
Post by: wildgoody on September 22, 2010, 10:13:34 pm

Those are welded on balancing weights not alignment marks

Title: Re: Drive Shaft
Post by: Drone637 on September 22, 2010, 10:39:38 pm

http://www.acksfaq.com/driveshaftvideo.htm (http://www.acksfaq.com/driveshaftvideo.htm)

That should help a bit.  :)

Title: Re: Drive Shaft
Post by: Skyhiranger on September 23, 2010, 05:21:55 am

Quote from: wildgoody on September 22, 2010, 10:13:34 pm

Those are welded on balancing weights not alignment marks

That is what I was guessing he was looking at too.

Title: Re: Drive Shaft
Post by: jow003 on September 23, 2010, 06:32:53 am

haha that makes SO much more sense!