ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: tracker8wr on June 17, 2004, 03:26:12 PM

Title: lock-right install?
Post by: tracker8wr on June 17, 2004, 03:26:12 PM: i put it in my 94 tracker standard and the passenger wheel does not lock in it jut grinds on the gears. what the hell is going on and also i had 2 washers on either side not one. should i put them both in or just one like instructions say. we put my friends to gether with no problem.
Title: Re: lock-right install?
Post by: Kreg on June 17, 2004, 05:45:51 PM: Not sure about the thrust washers. My truck only had one on each side.

Are you running the Lockrite that uses the stock side gears?

Perhaps your passenger side gear is worn out and isnÃ¢â‚¬â„¢t meshing properly with the coupler. ???
Title: Re: lock-right install?
Post by: tracker8wr on June 17, 2004, 07:16:28 PM: i checked the gearts like it said on the install booklet. it looked to be in good condition. i am running the stock gears. i don't think that is the problem. i am going to have to wait till next week to pull it part so until then i will be trying to get some ideas. i just bought a house so it is rquiring ALL of my time right now. any more suggestions.
Title: Re: lock-right install?
Post by: xamtex on June 18, 2004, 11:33:22 AM: if you had 2 thrusts in each side then you need 2 thusts each side!the lockright utilises your origional couplers and thrusts,if it needed 2 thrusts as standard then you need 2 thusts with the locker. ;)