ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: suzi_n_sammy on May 27, 2004, 11:25:56 AM

Title: Bolt Size
Post by: suzi_n_sammy on May 27, 2004, 11:25:56 AM

Do any of you know the size of the drain plug on a samurai's transfer case? Its an 88 but im pretty sure they used the same case in all sammy's. Thanks mucho.

Title: Re: Bolt Size
Post by: suzi_n_sammy on May 27, 2004, 03:10:35 PM

OHHHH. . .i get it ignore the new guy ;)

Title: Re: Bolt Size
Post by: tracker8wr on May 27, 2004, 03:20:29 PM

don't know it is metric. on track/ kicks they use a 1/2" driver plugs into the plug.

Title: Re: Bolt Size
Post by: DaddyDave on May 27, 2004, 03:44:45 PM

i know that damn near every bolt on the engine is a 10 or 12 mm  ;D

Title: Re: Bolt Size
Post by: Rollerskate on May 27, 2004, 06:06:44 PM

Actually there were two styles of drain plugs used on
Samurai T-cases,not sure when the change occured
but it might have been 88 1/2.Early ones had a 24mm
hex head and a M18-1.5 thread.They have an aluminum
washer that should be replaced for a good seal and the
torque spec is 26.5 to 39.0 foot pounds.Later plugs
have a 10mm square hole in them and a 1/2 pipe
thread.Use some teflon tape on these and torque
to approx two grunts.
:P

Title: Re: Bolt Size
Post by: Ronzuki on May 28, 2004, 12:25:49 AM

Interesting......learn something new everyday ;)

Title: Re: Bolt Size
Post by: Bobzooki on May 28, 2004, 01:31:01 AM

Quote

torque to approx two grunts.  :P

Are those metric grunts, or American Standard grunts?  And is that from a squat, or just in a standing position?

Title: Re: Bolt Size
Post by: suzi_n_sammy on May 28, 2004, 03:22:34 PM

in the manuel it says to squatting metric
thanks rollerskate.