ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Classified Ads => Topic started by: lazzer408 on August 31, 2011, 12:47:30 AM

Title: WTB - Aluminum front axle. 4.625:1 Need complete with half shafts and hubs.
Post by: lazzer408 on August 31, 2011, 12:47:30 AM

I'm putting AWD into my 2wd X-90. From what I've read it's a 4.625:1 rear end so I'll need the same ratio in front.

I'll need the front diff and housing (aluminum) and both half shafts. I'll also need the front driveshaft and the hubs that don't have an auto or manual lock. I need the hubs like an '02 Tracker would have. It's the piece held on with 6 bolts that the end of the halfshaft sticks into.

The conversion is a full time AWD t-case (single mode) from a '07 Vitara. Along with the v6. :)

I'm in Illinois. I figured I'd check here before I hit the yards.

Title: Re: WTB - Aluminum front axle. 4.625:1 Need complete with half shafts and hubs.
Post by: fullsink18 on September 01, 2011, 11:24:33 AM

I have the front housing,
intermediate shaft (the one the cv bolts to)
and the passenger side cv

If you are interested let me know.  Does $40 + shipping sound fair?

Title: Re: WTB - Aluminum front axle. 4.625:1 Need complete with half shafts and hubs.
Post by: zuksofhazzard on September 03, 2011, 07:02:13 PM

I have a COMPLETE Front end from a '96 Tracker I'm parting.

I believe the Ratio is 4.30 though. You may want to confirm YOUR ratio before you get too far. I believe Auto Transmission in the Tracker/Sidekick from '95 to '98 were 4.30. Another guess, the X90 will be the same.

I'm on the Western Side of Iowa...

Keep me in mind...

Thanks...

Title: Re: WTB - Aluminum front axle. 4.625:1 Need complete with half shafts and hubs.
Post by: Skyhiranger on September 06, 2011, 06:16:54 AM

All x90s have a 4.625 gear ratio.
The 94-98 (and maybe later) 2 door trackicks with the 1.6 16V and the 3 speed auto had 4.30 gears.