ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Build Diaries, How-To, DIY => Topic started by: chevytracker on September 29, 2011, 10:03:02 AM

Title: How Do You Remove? Passenger side CV Half Shalf 01 Tracker
Post by: chevytracker on September 29, 2011, 10:03:02 AM

I have to replace my passenger side CV Driveshaft or Half Shaft, I can remove the hub retaining clip and understand the inboard joint is the same, do I have to open transfer case???  I hate those retaining clips.

Title: Re: How Do You Remove? Passenger side CV Half Shalf 01 Tracker
Post by: talonxracer on September 29, 2011, 10:52:26 AM

The pass side should pop right out, it is only held in with a hog ring.

Title: Re: How Do You Remove? Passenger side CV Half Shalf 01 Tracker
Post by: wildgoody on October 02, 2011, 10:29:55 AM

If it won't come out with a pry bar or a big screw driver, the inside clip
"hog ring" might be too far expanded and be stuck, you can remove the
CV only and put the new one into the old cup.

I had to beat the living crap out of a 26 spline long side to get it out, finally
the ring broke in half and let the shaft come out, but I got a set of GV shafts
for my kick

Wild