ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Technical Discussion - Beginner / Repair => Topic started by: bigmuddin87 on March 02, 2012, 03:46:09 PM

Title: need torque specs
Post by: bigmuddin87 on March 02, 2012, 03:46:09 PM

what are torque specs for rocker arms on the cam (jam nut)?

Title: Re: need torque specs
Post by: bentparts on March 02, 2012, 05:39:19 PM

For what? Diesel locomotive engine? 1903 Evinrude V TWIN ? Bugatti Veyron? You get where I'm goin with this right?  ???
Just a bit more detail on what your working on would help, Sammy 1.3, 1.6 8V, 16V, 2ltr, etc.  :)

Title: Re: need torque specs
Post by: bigmuddin87 on March 03, 2012, 09:35:30 PM

1.6l 16v. I find it.

Title: Re: need torque specs
Post by: z0mb1emutha on March 14, 2012, 08:08:31 AM

Once this drag is felt, tighten the locknut to 133-168 inch lbs. (15-19 Nm) while holding the adjusting screw to prevent it from turning. This may seem harder than it sounds and may take you several attempts to get the knack for it.

Title: Re: need torque specs
Post by: Nick1236 on March 15, 2012, 09:07:43 PM

13 ft/lbs. I just did this a couple days ago.