ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Technical Discussion - Beginner / Repair => Topic started by: flanny on March 05, 2012, 12:39:04 PM

Title: snorkeled exhaust
Post by: flanny on March 05, 2012, 12:39:04 PM

need some advise on where to snorkel my exhaust? im trying to figure out how to run my exhaust for high water, as some of you already know i have a 91' sammy with a 11" lift and a ford v8 302 HO under the hood well partially :laugh: :laugh:
any ideas on routing it for the pipe for high water?

Title: Re: snorkeled exhaust
Post by: mrfuelish on March 05, 2012, 03:02:20 PM

the muffler on my Willy's has the pipe going through it all the way for strength and has a three bolt flange on the end of the tail pipe to bolt the snorkel to. you will have to brace the snorkel some how? my Willy's has a bracket with a pin in it.

Title: Re: snorkeled exhaust
Post by: flanny on March 06, 2012, 05:22:57 AM

so yours is running out the rear? im really just trying to decide where to run the pipe out at.

Title: Re: snorkeled exhaust
Post by: mrfuelish on March 06, 2012, 05:14:57 PM

I don't have the pipe but it did have one at one time and it looks like it just went up at the back corner, It has a plug to go into the bell housing and the vac stuff on the carb. (maybe pressure for the dist cap?) if you have the front pipe also.

Title: Re: snorkeled exhaust
Post by: WAGON08 on March 06, 2012, 06:17:18 PM

   I dont know what he is worried about because i haven't seen him put it in anything over the frame yet!!! lol

Title: Re: snorkeled exhaust
Post by: flanny on March 08, 2012, 11:26:32 AM

well over the frame would be over your head so it would be hard for u to get a close look :laugh: :laugh: :laugh:

Title: Re: snorkeled exhaust
Post by: Drone637 on March 12, 2012, 04:22:48 PM

Just flip your headers upside down.  Straight through the hood!  :D