ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum
ZUKIWORLD Discussion Forum => Technical Discussion - Performance / Modify => Topic started by: zuki1018 on April 08, 2012, 05:23:01 PM
-
Heres a close up:
(http://a7.sphotos.ak.fbcdn.net/hphotos-ak-ash4/405015_10150791848856464_567406463_9770193_934618792_n.jpg)
I dont see the same cracks on the outside but there is definitely fractures/cracks visible. I probably should be looking for a new case right?
TIA
-
Not necessarily. I saw some similar " cracking" in on the inside of my t case and I believe they are just from the casting process. I don't think these are die cast, more like sand cast, and those are just normal flaws. Gotta say though, there's a few more in yours than mine. Wouldn't worry about it too much.
-
I have seen what looks like cracks too. I think they are normal like was said. There is no pressure in the case so unless they are leaking out the cracks, I wouldn't worry.
-
Not necessarily. I saw some similar " cracking" in on the inside of my t case and I believe they are just from the casting process. I don't think these are die cast, more like sand cast, and those are just normal flaws. Gotta say though, there's a few more in yours than mine. Wouldn't worry about it too much.
I know exactly what you have seen, I have seen them many times as well. I was told it is a spot where the liquid aluminum didnt flow uniformily going into the mold.
But I would double check just to make sure, there seems to be alot of them radially from that pocket.
-
Those "veins" are completely normal. Every zuk tcase I have had apart has had them.
-
Thanks for all of the responses.