ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Technical Discussion - Beginner / Repair => Topic started by: RJkick on September 04, 2012, 09:55:20 AM

Title: What is the best way to get the "milkshake" out after head gasket replacement
Post by: RJkick on September 04, 2012, 09:55:20 AM

Only thing I know of is run a couple oil changes through (oil and filters) - I'm thinking 2 and make the 3rd the final oil change

I heard something about Mysery oil or something like that but not sure

Any thoughts

Thanks

Title: Re: What is the best way to get the "milkshake" out after head gasket replacement
Post by: c3006 on September 04, 2012, 12:14:22 PM

I drain the filter that was on it and wash it out with a little gas then put it back on and run the cheap Walmart oil $13 a gallon for a complete heat cycle.  Then drain and put on a new filter with good oil and have never seen a bit of contaminated oil after that.  c

Title: Re: What is the best way to get the "milkshake" out after head gasket replacement
Post by: RJkick on September 05, 2012, 10:32:09 AM

thanks