ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: 1bigtracker on April 04, 2004, 03:47:25 AM

Title: sammy case mated to a tracker case?
Post by: 1bigtracker on April 04, 2004, 03:47:25 AM

is their any easy way to do this without sending them to OTT.  my friend has a alum. welder so he can cut the output off my case and weld it up.  i have never seen a sammy case.

stu

Title: Re: sammy case mated to a tracker case?
Post by: Wildweasel on April 04, 2004, 07:26:24 AM

Unless you push your rear axle back (6") the rear driveshaft
will be too  short. My outdated web pages have info and some pics on doing this.  

Title: Re: sammy case mated to a tracker case?
Post by: idaholwb on April 04, 2004, 12:56:47 PM

 The kicker setup only requires shipment of the kick case. He hasn't gotten around to taking the other part off the website yet. The kicker is about 1 1/2" shorter than stock, minus the extra length you would need for the intermediate driveline and sammy case input flange.....bare minimum of 6"!
Easier to go through OTT, they already have it figured out. And it really isn't that expensive.

Title: Re: sammy case mated to a tracker case?
Post by: whitfield on April 04, 2004, 05:37:11 PM

Quote

Unless you push your rear axle back (6") the rear driveshaft
will be too  short. My outdated web pages have info and some pics on doing this.  

But I've got a 4dr... ;D   Gotta look into this.  I have a few sammy cases laying around

Title: Re: sammy case mated to a tracker case?
Post by: Wildweasel on April 04, 2004, 10:52:49 PM

Ott is the way to go for sure, bt he was asking if you can do it without OTT. (I did mine just before they released the ott3 I think) and I didn't have the funds then anyway,
My rear driveshaft is 18 1/4" long. (toy CV type) and the driveline angles arn't bad so there have been no problems with it.

Title: Re: sammy case mated to a tracker case?
Post by: whitfield on April 04, 2004, 11:07:01 PM

Thanks Wildweasel,   Nice to know that it can be done sucessfully at home in the shop, where things cost much less.  I have been checking out  your web page on the WW3.   Any more updates?


OOOOh   I see!   nice.

Title: Re: sammy case mated to a tracker case?
Post by: Wildweasel on April 05, 2004, 01:13:09 AM

If I have some time at work this week I am going to try to get some updates on the site, I just have been kind of busy as of late. My site is out of date as to what I have done on the Tracker.  (Now evan more so)
I will post a link to the updates when I get to them.