ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: midget on February 07, 2004, 10:38:03 AM

Title: hi there all
Post by: midget on February 07, 2004, 10:38:03 AM

hey there everyone im new to the board and am already looking for help.  ive got an 87 sammy with a bad rear tranny seal, ive got the driveshaft out but cant seem to pull the old seal.  any advice.    thanks in advance ???



dave

Title: Re: hi there all
Post by: wildgoody on February 07, 2004, 07:04:13 PM

Hello Dave, welcome to the forum  ;D
I got a small slide hammer with a screw
the fits on the end, like the ones you
would use to pull out body dents,
take that and either drill a small pilot
hole, about 1/16" or if the seal has a
groove around it like my trans had and
screw that thing in, now wack it with the
slide hammer and it should pop right out  ;)

Good Luck
Darrin

Title: Re: hi there all
Post by: lil_Truck on February 08, 2004, 11:18:19 AM

I just use a smaller screw driver.  drive it in with a hammer into the tin metel part of the seal.  Now pry it out.  Then tap the new one in.

Title: Re: hi there all
Post by: midget on February 09, 2004, 10:30:50 AM

thanks for the help guys . i just finished getting the thing back together tonight. hopefully nothing else goes wrong until it get warmer



dave