ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: cuban_b on May 05, 2005, 03:02:38 PM

Title: T-case flange question
Post by: cuban_b on May 05, 2005, 03:02:38 PM

Is the t-case output flange interchangeable with the axle pinion flange?

Title: Re: T-case flange question
Post by: Natebert on May 05, 2005, 03:22:01 PM

Don't think so on Sammy or Sidekick
Size/Spline differences on Sammy.  (bolt pattern should be the same)

And on a kick one is a slip, where the other isn't.

~Nate

Title: Re: T-case flange question
Post by: cuban_b on May 05, 2005, 03:39:59 PM

On a samurai, I probably should have mentioned that.  The flange appears to be the same size, but are the splines different?

Title: Re: T-case flange question
Post by: cuban_b on May 07, 2005, 09:10:54 AM

any help would be appreciated.

Title: Re: T-case flange question
Post by: rockrat on May 10, 2005, 09:37:55 AM

I think either the front input or output was the same, I know the rear out is different length.