ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum
ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: ksa421 on July 13, 2005, 04:31:52 PM
-
(http://www.omghi2.us/april05/enginew.jpg)
Well my TD swap is just about done and now I need some new tires. I am looking at the 34x10.50 LTBs. I have the 6" combo lift. What do I need to do to get these to fit. Right now the front end sits a littel lower than the rear. I think this is either form the springs saggin a little or some slightly bent strut towers. I am hoping a set of spring sapcer will correct this.
Will I have to pound back my floor panles at all? I already cut my fenders back a little and I am not worried about cutting more though? Any thoughts on getting these to fit would be great.. Thanks
jacob
Also how are the LTBs onroad? I know they do great offroad but they are bias ply so I am a wondering if they are unberable on road or not.
-
If you are wearing 32's now ... then stuff them, and crank them around and figure you'll need an extra 1" at the fender wall/lip, and probably another 1/2" at the frame.
My guess, you'll have to pound the firewall back some inside the front rear. Probably some more fender trimmig front AND back as well.
-
you can easly fit the 34's with the 3+3. you will need to trim the fenders back alittle more and push the floorboards back some but they should fit nicely. welcome to the club, the big tire club ;D ;)
stu
P.S. your making me want to do somthing with the TD in the corner of my shop :D
-
I am excited to get it done... I drove a sammy w/ 31s or 32s and stock gears I think with the same motor and it felt like the same power i hade with the kick motor, but i got all my power right of the bat.