ZUKIWORLD Online | Suzuki 4x4 Editorial and Forum

ZUKIWORLD Discussion Forum => Suzuki 4x4 Forum => Topic started by: wezzlegod on March 28, 2005, 11:50:03 AM

Title: fender cuting
Post by: wezzlegod on March 28, 2005, 11:50:03 AM

 i  want to put 32S on my sidekick and was woundering how much to cut out of my fenders. can i get some of you that have allready put 32s &33s post some closeup picks of this mod so i can do it right ? thanks :) :) :) :) :) :)

Title: Re: fender cuting
Post by: HotRod on March 28, 2005, 01:33:23 PM

Sure. be back in  a moment ;D
From this
(http://memimage.cardomain.net/member_images/4/web/496000-496999/496556_27_full.jpg)
To this
(http://memimage.cardomain.net/member_images/4/web/496000-496999/496556_26_full.jpg)
Just use some pinstiping tape to make a good line from the body line to as far down & back as the inner body is.
CUt with in 1/2 to 3/4 inch from the tape, and slowly with a small pair of pleirs fold ove the edge to make a lip.
Then with a BFH, bend over the inner lip on the tub, flat against the floor..

Title: Re: fender cuting
Post by: Natebert on March 29, 2005, 04:33:07 AM

An angle grinder with a cut-off wheel works great too.
Free hand it.

~Nate

Title: Re: fender cuting
Post by: Bobzooki on March 29, 2005, 04:46:35 AM

Something like this, but go straight down from the point farthest to the rear:

(http://img220.exs.cx/img220/1252/wheelcut9sn.jpg)

You don't really need to cut the top higher (besides, that's where the snorkel comes out).