hey i was wondering if anybody knew the maximum angles the toy cv's operate at. like what angle the inner cv will go to without binding and more importantly the outer cv that is in the spindle what is its operating angle?? any help would be very very appreciated. or if you know where to find some info let me know. thanks

shane

I don't know the exact angle.  but with some checking could get some angles.   stan

What toy shafts are you running, and how much modding is needed.
Brian

Maybe Eric could put a sticky on the Toy article already posted to keep it at the top of the forum. What do you think Eric?

Bill

ive searched but havnt havent found any toy article in here. oh well ya eric see if you can dig up some info or stan if you could get any type of measurments for me that would be great. and what is the angle for the cv's stock?

shane

C'mon Eric!  I know you don't have anything else going on.  Put the link up already, jeesh.
Brian

hey i was wondering if anybody knew the maximum angles the toy cv's operate at. like what angle the inner cv will go to without binding and more importantly the outer cv that is in the spindle what is its operating angle?? any help would be very very appreciated. or if you know where to find some info let me know. thanks

shane

did some checking the handy dandy angle finder if correct says 24-25 degrees .  stan

I got 25* on the inner CV that has the cup,
and 40* on the outer CV without the cup.

I don't know if the CV will go that far without
breaking, but they will flex that far.