just wondering if any one has removed their dash in their vits/kicks?

i had a look at it already, and there are a few screws holding the bottom of the dash in, and then there are about 3 screws up on top near the windsheild.

where are the other screws which hold the dash in, and are there any tricks or tips to how to take the dash out?

i'm going to be installing my alarm system in soon, and i also want to clean up all the wiring under the dash, and get rid of what i dont need.

any one got any pics?

thanks.

Seems to me there were some screws on the
side of the dash too, where the door panel
closes against

    Hammer, Chainsaw, Prybar
   
  ohhh you want this to go back together again LOL all I can say from watching techs do it at work is take your time and pay attention to detail they do come apart and go back together again, they don't seem that difficult compared to others I've seen.
   here at LMS we use the Hammer, Chainsaw, and prybar when building our Demo Cars. we just got invited to next years school bus demo derby


BEFORE

AFTER

Oouch