Hello Guest
« previous next »
Pages: [1]   Go Down

Leaf Springs in SAS setup

  • 7 Replies
  • 3171 Views

0 Members and 1 Guest are viewing this topic.

*

dan_b_grcc

Leaf Springs in SAS setup
« on: August 06, 2007, 09:18:17 AM »
Hello,
  What kind of leaf springs are some of you guys using with your SAS setups for Tracker/Sidekicks?  I am wondering about using some rears from a Chevy S-10 or Ford Ranger, just because of there smaller length. Any ideas or advice? Just curious what others have done. I have seen some information on the axles here, but not much on the leaf springs. I plan on using Dana 44's from a Jeep Grand Wagoneer. Thank you
Logged
*

Offline whateverworks

  • 110
  • 0
  • I Love ZUKIWORLD!
Re: Leaf Springs in SAS setup
« Reply #1 on: August 06, 2007, 07:06:04 PM »
I have seen both 4pack and 5pack jeep yj leafs being used with great success
Logged
*

Offline trailturd

  • 45
  • 0
  • Gender: Male
  • meatwad gets all the ladies
Re: Leaf Springs in SAS setup
« Reply #2 on: August 06, 2007, 09:33:37 PM »
I am using 5-leaf pack YJ's. They work pretty well.
Logged
*

dan_b_grcc

Re: Leaf Springs in SAS setup
« Reply #3 on: August 07, 2007, 04:16:08 PM »
Thanks for the response guys. What axles are you running with them? Do you have pictures by chance?

Thanks!
Logged
*

Offline whateverworks

  • 110
  • 0
  • I Love ZUKIWORLD!
Re: Leaf Springs in SAS setup
« Reply #4 on: August 07, 2007, 09:31:40 PM »
Most guys set em up with Toyota axles.
Kelly
Logged
*

Offline hcgalvin

  • 1695
  • 1
  • Gender: Female
  • Roads? Where we're going, we don't need roads.
    • Granite Path
Re: Leaf Springs in SAS setup
« Reply #5 on: August 08, 2007, 07:06:48 AM »
See signature. Go to links in said signature.  ;)
Logged
Heather Galvin
2005 GV with Zuki Nation 4.5" Lift.
Sidekick's gone... Still have Bob's Knob.
*

Offline 95tracker

  • 104
  • 0
  • Gender: Male
  • It'll fit Perfect!!!
Re: Leaf Springs in SAS setup
« Reply #6 on: August 08, 2007, 07:45:32 AM »
I am in the process in a SAS with 4 pack Yj leafs, and i am using a CJ Dana 30, the axle is about an inch narrower than the tracker track width but it was free, and a lot easier for me to find than Yota axles.
Logged
*

dan_b_grcc

Re: Leaf Springs in SAS setup
« Reply #7 on: August 08, 2007, 12:03:21 PM »
Thank you for the replies, girls and guys.


 :)
Logged
Pages: [1]   Go Up
« previous next »