Hello Guest
« previous next »
Pages: [1]   Go Down

How can I water proof the auto trans.

  • 2 Replies
  • 1246 Views

0 Members and 2 Guests are viewing this topic.

*

Offline whitfield

  • 633
  • 0
  • Gender: Male
  • 4-dr Kick on 34's
How can I water proof the auto trans.
« on: February 11, 2008, 07:46:58 PM »
I want to take my 4wd Tracker 95 16v Auto on a trail run but their are a few creek crossig that are known to run a little deep in the winter.  I'd drive somthing bigger but it is a 5 hr hwy round trip.

How can I preserve the auto trans?  Plum the vent line inside?  Where is the auto trans vented?  97 Jeep TJ auto trans vent is in the bell housing just above the main shaft and kills the trans about the time the hubs take a drink.

Any thing else I need to make water tight before my trip? 
Logged
Old Dog looking to learn some new tricks. 

*

Offline wildgoody

  • *
  • 8134
  • 67
  • Gender: Male
  • Turbocharged 150HP 1.6L 8V 93MPH 1/4 mile
Re: How can I water proof the auto trans.
« Reply #1 on: February 12, 2008, 12:20:24 AM »
Vent is at the back of the engine by the bell housing, good for water up to the intake.
You might spray some silicone spray on the dizzy and grease the plug wires with dilectric grease
to prevent water grounding

Wild
Logged
Real Trucks Are Built, Not Bought,
And Chrome Don't Get Ya Home.  

An armed man is a citizen. An unarmed man is a subject.
*

Offline whitfield

  • 633
  • 0
  • Gender: Male
  • 4-dr Kick on 34's
Re: How can I water proof the auto trans.
« Reply #2 on: February 12, 2008, 04:47:38 AM »
Thanks Wild !!!   :D   

Looks like I may be good to go, as I don't plan on getting water in the doors.



Logged
Old Dog looking to learn some new tricks. 

Pages: [1]   Go Up
« previous next »