What is the best way to get the "milkshake" out after head gasket replacement

RJkick

632
5
Gender:

What is the best way to get the "milkshake" out after head gasket replacement

« on: September 04, 2012, 09:55:20 AM »

Only thing I know of is run a couple oil changes through (oil and filters) - I'm thinking 2 and make the 3rd the final oil change

I heard something about Mysery oil or something like that but not sure

Any thoughts

Thanks

Logged

92 Sidekick 1.6L 16v Calmini\OME 4.5" lift 3" Body Lift OME962 springs in front w\.75" spacers OME955 in rear w\1.75" spacers Extreme Duty Strut Eliminator kit and rear ProComp MX6 Shocks 31X10.50 Nexen M\T Thorley Header 2" exhaust Calmini front truss bar and stabilizer and skids Custom Bumpers and Rock Rails Limit Straps

c3006

263
10

Re: What is the best way to get the "milkshake" out after head gasket replacement

« Reply #1 on: September 04, 2012, 12:14:22 PM »

I drain the filter that was on it and wash it out with a little gas then put it back on and run the cheap Walmart oil $13 a gallon for a complete heat cycle. Then drain and put on a new filter with good oil and have never seen a bit of contaminated oil after that. c

Logged

RJkick

632
5
Gender:

Re: What is the best way to get the "milkshake" out after head gasket replacement

« Reply #2 on: September 05, 2012, 10:32:09 AM »

thanks

Logged

92 Sidekick 1.6L 16v Calmini\OME 4.5" lift 3" Body Lift OME962 springs in front w\.75" spacers OME955 in rear w\1.75" spacers Extreme Duty Strut Eliminator kit and rear ProComp MX6 Shocks 31X10.50 Nexen M\T Thorley Header 2" exhaust Calmini front truss bar and stabilizer and skids Custom Bumpers and Rock Rails Limit Straps