Hello Guest
« previous next »
Pages: 1 2 [3]   Go Down

manual hubs: what I think . . .I think

  • 31 Replies
  • 6107 Views

0 Members and 1 Guest are viewing this topic.

*

Offline the_maplebar

  • 466
  • 0
  • Gender: Male
Re: manual hubs: what I think . . .I think
« Reply #30 on: May 25, 2006, 09:24:26 AM »
The hardness of a bolt would determine how much torque it can withstand right?

My manual with the Drive Flanges says 36.5 ft-lbs
Autozone (Haynes?) for TracKicks says 18 ft-lbs
Aisin rebuild .pdf say 23 ft-lbs

Does any of that match the factory manual for TracKicks?
Is my reasoning correct, so my stock bolts should be fine?
Logged
2002 4DR Tracker V6 ZR2.... 1.5"/2" coil spacers front/rear, BDS Strut Extensions, 235/75R15 Cooper STT... They ROCK!!!
http://www.zukiworld.com/forum/index.php?topic=35.msg111575#msg111575[/url]
*

Offline Rhinoman

  • 4502
  • 36
  • Gender: Male
  • Bend it, Break it, Fix it
    • Rhinoman
Re: manual hubs: what I think . . .I think
« Reply #31 on: May 25, 2006, 12:33:17 PM »
My FSM says 14.5- 21.5 lb/ft
Logged
2000 Vitara 1.6, 3+3 Lift, 33"MTs, 5:83s, LWB brakes, Winch, Snorkel, Safari Rack
1986 SJ413K PickUp, 1.6L conversion.

OBD1 - Full diagnostics on a PC/Laptop: http://www.rhinopower.org
Pages: 1 2 [3]   Go Up
« previous next »