Hello Guest
« previous next »
Pages: [1]   Go Down

Wheel Studs

  • 2 Replies
  • 1393 Views

0 Members and 1 Guest are viewing this topic.

*

Offline Havoc_Smirf

  • 21
  • 0
  • Gender: Male
  • HavocOffroad.com
    • HavocOffrad
Wheel Studs
« on: January 21, 2006, 05:04:18 AM »
What size wheel studs would I need on my samurai?  I got a couple that need to be replaced and I want to fab up a spare tire carrier.   Appreciate the help.
Logged
1988 Suzuki Samurai - 6" lift, 28" Thornturds, Welded rear, Rear 3rd member up front w/ Calmini 26 spline axles shafts w/ EZ-Locker, Full-Cage, Running on Propane!

1999 F250 - Fabtech lift, 37" SSR, Autometer Guages, Edge Evolution
*

Offline mrfuelish

  • *
  • 2862
  • 13
  • Gender: Male
  • you must have a perception problem.
Re: Wheel Studs
« Reply #1 on: January 21, 2006, 08:39:25 AM »
If I remember they are 12mmx1.25 mm close to 30 mm long get them longer if you can mine are too short to run aluminum rims.
Logged
1987,1988,1988,1990 samurai's,  1953 m38a1,  1996 x-90,blue.1996 x-90 red.1994 2 door tracker.   only Dead Fish go with the flow.                No Hairy Nosed Wombats were ran over on the trail today.       My ZUK is Xenophobic.
*

Offline takai

  • 907
  • 0
  • Gender: Male
  • Yes, I drove that here. And No, it's not done!
Re: Wheel Studs
« Reply #2 on: January 21, 2006, 08:41:18 AM »
Quote from: mrfuelish on January 21, 2006, 08:39:25 AM
If I remember they are 12mmx1.25 mm close to 30 mm long get them longer if you can mine are too short to run aluminum rims.

Wasn't quite sure on the length but the 12X1.25 matches what I got.
Logged
87 Sammi "Sir Tweak " Rockcrawler 4:1, Mighty Kong , 1.6 16V, Centerforce II, 2" Exhaust, Esteem seats. - Long gone
97 Tracker "Jezebel"  Bone Stock DD

'Cause, I am to misbehave.
Pages: [1]   Go Up
« previous next »