Hello Guest

restoring plastic bumper

  • 15 Replies
  • 4024 Views

0 Members and 1 Guest are viewing this topic.

*

Offline nuts4hotwheels

  • 169
  • 1
  • Gender: Male
  • Black Sunshine
restoring plastic bumper
« on: February 13, 2008, 10:03:23 AM »
 my bumpers and trim is faded. Is there a way and/or product to restore it?
*******************************
Black Sunshine
1998 4 dr Chevy Tracker 4x2 1.6L-16V
-K&N Performance Air Filter
-Thrush Glasspack -235/75-15 Pathfinder Trail A/P Tires  -Sony Xplod Cd Player -400W Visonik amplifier -2 10" Visonik Subwoofers *******************************

*

big_kountry21

Re: restoring plastic bumper
« Reply #1 on: February 13, 2008, 10:37:04 AM »
try baby oil.....that did it for my bronc. its better than armor all. great for dashes too doesn't crack em over time.

*

Offline justzukies

  • 88
  • 1
  • Gender: Male
  • I Love ZUKIWORLD!
Re: restoring plastic bumper
« Reply #2 on: February 13, 2008, 11:02:35 AM »
for black trim BACK TO BLACK by mothers works great, its an oil/wax at like product. as far as the plastic bumper covers go you can remove them and there is a metal bumper underneath.
94 kick 1.6 16V AT 4dr  Calmini 3" lift

*

Offline crikeymike

  • 713
  • 0
  • Gender: Male
  • Local to Western Washington?? Visit WAZUKS.com
    • http://www.wazuks.com
Re: restoring plastic bumper
« Reply #3 on: February 13, 2008, 02:35:05 PM »
There's black plastic spray paint you can buy from the auto parts store, and it worked great on my wife's tracker.  Lasted about 3 years before it kinda chipped off a bit, but it looked great for a long time.

Duplicolor was the brand i think.
1993 4-door Sidekick
3" hybrid Calmini/OME lift, 2" B/L, Rear air locker
Shrockworks bar & sliders, Full skid plates
4.24:1 t-case
 WAZUKS member - visit http://www.wazuks.com

*

Offline Jeremiah

  • 1880
  • 1
  • Gender: Male
  • Viva La ZUKIWORLD!
Re: restoring plastic bumper
« Reply #4 on: February 13, 2008, 04:18:15 PM »
I've not found a product that does well "restoring" plastic to it's original luster, but then - I've not tried everything under the sun.

However, I've had great luck with Krylon Fusion (spray paint) on plastics. Just make sure you watch your prep.
'96 4 door kick: 29" Pep-Boys M/T, 1.5" OME
'83 SJ410: 31" Toyo M/T, SPOA, 1.3L
'08 Yamaha FZ6

*

Offline ebewley

  • 6566
  • 66
  • Gender: Male
  • ZUKIWORLD Online, Editor
    • ZUKIWORLD online
Re: restoring plastic bumper
« Reply #5 on: February 13, 2008, 04:24:23 PM »
WD-40.... Seriously.

-Eric
Eric L. Bewley                               
Editor, ZUKIWORLD Online                   

Suzuki 4x4 Owners Association - Please Join  The ZUKIWORLD ORDER Today!
About ZUKIWORLD Online: We are an enthusiast web site dedicated to the promotion of the Suzuki Automobile as the best and most capable vehicle on the planet. We offer product reviews, Tech tips, DIY, Travel and Adventure, Forum, Technical information, Life Style, and so much more!

*

Offline Rhinoman

  • 4502
  • 36
  • Gender: Male
  • Bend it, Break it, Fix it
    • Rhinoman
Re: restoring plastic bumper
« Reply #6 on: February 14, 2008, 04:53:44 AM »
2000 Vitara 1.6, 3+3 Lift, 33"MTs, 5:83s, LWB brakes, Winch, Snorkel, Safari Rack
1986 SJ413K PickUp, 1.6L conversion.

OBD1 - Full diagnostics on a PC/Laptop: http://www.rhinopower.org

*

Offline nuts4hotwheels

  • 169
  • 1
  • Gender: Male
  • Black Sunshine
Re: restoring plastic bumper
« Reply #7 on: February 14, 2008, 09:49:14 AM »
 I will try the WD-40 this weekend and post before and after pics
*******************************
Black Sunshine
1998 4 dr Chevy Tracker 4x2 1.6L-16V
-K&N Performance Air Filter
-Thrush Glasspack -235/75-15 Pathfinder Trail A/P Tires  -Sony Xplod Cd Player -400W Visonik amplifier -2 10" Visonik Subwoofers *******************************

*

Offline trackinstile

  • 435
  • 0
  • Gender: Male
  • Too young to quit........Too old to change........
Re: restoring plastic bumper
« Reply #8 on: February 14, 2008, 01:38:24 PM »
Do you soak it on the bumbper and then rub it in or soak it on the rag and wipe on?  WD stands for water displacement.  And it was the 40th formula they came up with.  I am going to have to try it.  Dave..    ps,. please post before and after pics if you can, my trim is grey and needs help. 
A wise man once said, "Wherever you go...........There you are.............." 2000 Tracker 4 door with the 2.0 liter "Big Block". 5 speed 4WD  2001 XL-7 EX II

*

Cuthulu

Re: restoring plastic bumper
« Reply #9 on: February 15, 2008, 06:37:38 AM »
WD stands for water displacement.  And it was the 40th formula they came up with.  I am going to have to try it.  Dave..    ps,. please post before and after pics if you can, my trim is grey and needs help. 

I had always wondered, and I second the pic request.

Eric, how long does that hold up for usually?

Thanks

*

erik the red

Re: restoring plastic bumper
« Reply #10 on: February 15, 2008, 06:00:40 PM »
I've got the plastic stock "bumper" sitting in my garage you can have.

*

Offline trackinstile

  • 435
  • 0
  • Gender: Male
  • Too young to quit........Too old to change........
Re: restoring plastic bumper
« Reply #11 on: February 15, 2008, 06:34:11 PM »


I had always wondered, and I second the pic request.

Eric, how long does that hold up for usually?

Thanks
[/quote]

I found something on the web with some research about WD 40, it was an interesting story.  Unfortunatly I have the memory of a sloth, gotta look it up again.  Dave
A wise man once said, "Wherever you go...........There you are.............." 2000 Tracker 4 door with the 2.0 liter "Big Block". 5 speed 4WD  2001 XL-7 EX II

*

Cuthulu

Re: restoring plastic bumper
« Reply #12 on: February 16, 2008, 10:36:33 PM »

*

Offline trackinstile

  • 435
  • 0
  • Gender: Male
  • Too young to quit........Too old to change........
Re: restoring plastic bumper
« Reply #13 on: February 17, 2008, 06:08:14 PM »
THATS THE ARTICLE!!!!!! :laugh:
A wise man once said, "Wherever you go...........There you are.............." 2000 Tracker 4 door with the 2.0 liter "Big Block". 5 speed 4WD  2001 XL-7 EX II

*

Offline nuts4hotwheels

  • 169
  • 1
  • Gender: Male
  • Black Sunshine
Re: restoring plastic bumper
« Reply #14 on: February 18, 2008, 04:49:23 AM »
I guess my thread got hijacked :) , but here is more about WD-40:
_________________________________________________________

In 1953, a fledgling company called Rocket Chemical Company and its staff of three set out to create a line of rust-prevention solvents and degreasers for use in the aerospace industry, in a small lab in San Diego, California.

It took them 40 attempts to get the water displacing formula worked out. But they must have been really good, because the original secret formula for WD-40�which stands for Water Displacement perfected on the 40th try�is still in use today.

Convair, an aerospace contractor, first used WD-40 to protect the outer skin of the Atlas Missile from rust and corrosion. The product actually worked so well that several employees snuck some WD-40 cans out of the plant to use at home.

A few years following WD-40's first industrial use, Rocket Chemical Company founder Norm Larsen experimented with putting WD-40 into aerosol cans, reasoning that consumers might find a use for the product at home as some of the employees had. The product made its first appearance on store shelves in San Diego in 1958.

In 1960 the company nearly doubled in size, growing to seven people, who sold an average of 45 cases per day from the trunk of their cars to hardware and sporting goods stores in the San Diego area.

In 1961 the first full truckload order for WD-40 was filled when employees came in on a Saturday to produce additional concentrate to meet the disaster needs of the victims of Hurricane Carla along the U.S. Gulf coast. WD-40 was used to recondition flood and rain damaged vehicles and equipment.

 

 
 In 1969 the company was renamed after its only product, WD-40.

WD-40 Company, Inc., went public in 1973 and was listed Over-The-Counter. The stock price increased by 61% on the first day of listing.

Since that time, WD-40 has grown by leaps and bounds, and is now virtually a household name, used in numerous consumer and industrial markets such as automotive, manufacturing, sporting goods, aviation, hardware and home improvement, construction, and farming.

In 1983, WD-40 Company sales reached $50.2 million. Many companies attempted to introduce imitation products, going so far as to copy the distinctive blue, yellow and red colors of the WD-40 can.

In 1993, WD-40 Company celebrated its 40th anniversary by breaking the $100 million sales mark. That year the company was also listed among the Top Ten Most Profitable companies on the NASDAQ exchange. Not bad for a company with only one product!

WD-40 was found to be in 4 out of 5 American households (it seems everyone has a can or two) and was used by 81 percent of professionals at work. Sales had grown to more than one million cans each week.

The most interesting piece of WD-40's history is the uses for the product, now numbering in the thousands. The uses include everything from silencing squeaky hinges and removing road tar from automobiles to protecting tools from rust and removing adhesive labels. But they get a lot crazier than that.
 
*******************************
Black Sunshine
1998 4 dr Chevy Tracker 4x2 1.6L-16V
-K&N Performance Air Filter
-Thrush Glasspack -235/75-15 Pathfinder Trail A/P Tires  -Sony Xplod Cd Player -400W Visonik amplifier -2 10" Visonik Subwoofers *******************************