Hello Guest

Been fabing again...

  • 4 Replies
  • 1298 Views

0 Members and 1 Guest are viewing this topic.

*

mudfkr

Been fabing again...
« on: October 20, 2005, 02:22:50 PM »
It's a four day weekend here and we're going bush bashing for two days ;D ;D ;D so I thought I'd better get some front protection to stop the old tree in the radiator trick happening (again :'()



If it would just stop raining for an hour I can finish bolting it on, then it can rain all it likes cause that just makes the weekend more fun ;D.

I'm looking forward to Sunday as I'm trying some thing new out, I've brought a Garmin etrex Legend and have also purchased some mapping software that I can down load my trips onto once I get home and see where I've been for a change.

ROCK ON SUNDAY !!!!!!!  ;D

*

Offline crikeymike

  • 713
  • 0
  • Gender: Male
  • Local to Western Washington?? Visit WAZUKS.com
    • http://www.wazuks.com
Re: Been fabing again...
« Reply #1 on: October 20, 2005, 02:32:57 PM »
You mean you're trying to stop this from happening???

1993 4-door Sidekick
3" hybrid Calmini/OME lift, 2" B/L, Rear air locker
Shrockworks bar & sliders, Full skid plates
4.24:1 t-case
 WAZUKS member - visit http://www.wazuks.com

*

mudfkr

Re: Been fabing again...
« Reply #2 on: October 20, 2005, 03:01:09 PM »
Thats not such a problem as I carry my trusty Sthil with me  ;D

It's more when they go throgh the radiator or come up from underneath and take the fan blades out that it causes me a problem. It's 75Kms to the start of the trail and some times we're hours into the bush which is a PITA when your over heating and can't hold water.
 

*

Offline SnoFalls

  • 1358
  • 3
  • Gender: Male
Re: Been fabing again...
« Reply #3 on: October 20, 2005, 03:50:24 PM »
that was me ... and ya, I'm happy it missed important bits ... very close to tearing off that brakeline, a bit higher woulda got the fan blades, a bit higher than that and would speared the rad ...

« Last Edit: October 20, 2005, 03:52:10 PM by SnoFalls »
I don't suffer from insanity, I enjoy it.

Buy-it, Build-it, Beat-it, Part-it

*

Offline ghd23

  • 406
  • 0
  • Gender: Male
  • 1990 Tracker softop, Detroit Mi.
Re: Been fabing again...
« Reply #4 on: October 20, 2005, 04:08:26 PM »
From one fabman to another,  nice job
If I Can't Weld It          It Can't Be Welded