I have a 3/93 sidekick and need a pic of were the map sensor is I've searched and looked at my Haynes and am not sure which one it is. Thanks

I found a shot from under the hood that
I took when I was building the turbo setup



Hope this helps

WIld

If you have a 16 Valve, it doesn't have a MAP sensor - It's got a MAF sensor in the intake hose between the air filter box, and the intake manifold.

Hey Bob 
Nice Hair Cut   

Were 16V engines available in 93

Were 16V engines available in 93

yup 4dr sidekicks ...

actually 4dr sidekicks got the 16V in 92+ ...
trackers tho not till 94 in california, 95+ for the rest, ... go figure ...

If you have a 16 Valve, it doesn't have a MAP sensor - It's got a MAF sensor in the intake hose between the air filter box, and the intake manifold.

OOHH that why I couldn't find it It is a 16 valve

Hey Bob 
Nice Hair Cut   
Were 16V engines available in 93

Thanks!

My first 16-valve was on a 1992 4-door.

what does the map sensor do again??

what does the map sensor do again??

It loads a map into your HUD so you can plot your route through werever you are going right now 

MAP = Manifold Absolute Pressure.  It mesaures the pressure in the manifold. The ECU uses manifold pressure, air temperature and a value from a look up table (VE table) to calculate the mass of air entering the engine.

It loads a map into your HUD so you can plot your route through werever you are going right now 

Oh, that's old school -  have the image transferred directly into my brain by neural induction...

But the HUD woulda worked on the F-111D (other models of F-111 didn't have as much flexibility, as far as what they could put up on their pilot's-side-only optical display)...