Hello Guest
« previous next »
Pages: [1]   Go Down

Samurai Drive Shaft Spacers

  • 4 Replies
  • 2736 Views

0 Members and 2 Guests are viewing this topic.

*

Offline mbruce

  • 139
  • 2
  • Gender: Male
Samurai Drive Shaft Spacers
« on: June 20, 2011, 07:58:10 PM »
I have a typical SPOA and will soon do a RUF....I was told that I need a 1" spacer for the rear drive shaft, assuming bc of a spoa , and (2) 3/4" spacers for the front drive shaft for the RUF...

I don't have a spacer on the rear drive shaft and it seems to be OK?....

So I guess my dumb sounding question is how do you know when you need a drive shaft spacer? I'm assuming it's not ad simple as " you'll know" because I don't have one now and was told (by a popular vendor) that I should have a 1" rear spacer for my spoa...
Logged
Ignorant questions lead to a wealth of knowledge
*

Offline mrfuelish

  • *
  • 2862
  • 13
  • Gender: Male
  • you must have a perception problem.
Re: Samurai Drive Shaft Spacers
« Reply #1 on: June 20, 2011, 09:11:25 PM »
You should only have about an inch and a half of spline showing when you push the rubber dust cover all the way back to look.
Logged
1987,1988,1988,1990 samurai's,  1953 m38a1,  1996 x-90,blue.1996 x-90 red.1994 2 door tracker.   only Dead Fish go with the flow.                No Hairy Nosed Wombats were ran over on the trail today.       My ZUK is Xenophobic.
*

Offline mbruce

  • 139
  • 2
  • Gender: Male
Re: Samurai Drive Shaft Spacers
« Reply #2 on: June 21, 2011, 06:33:03 AM »
Cool -- Thanks!
« Last Edit: June 21, 2011, 06:39:13 AM by mbruce »
Logged
Ignorant questions lead to a wealth of knowledge
*

Offline Drone637

  • 8121
  • 116
  • Gender: Male
  • Evil Cow
Re: Samurai Drive Shaft Spacers
« Reply #3 on: June 21, 2011, 10:42:03 AM »
Verify that you need the spacer before you order one/put it on.  I have seen transfer case mounts destroyed due to the drive shaft being to short because of a spacer, so when the vehicle flexed it smashed the driveshaft into the transfer case.
Logged
96 Geo Tracker, x-SJ-410,  x-White Rabbit, x-Project Trouble
Crawlers NorthWest
x-Trouble Racing
*

Offline mbruce

  • 139
  • 2
  • Gender: Male
Re: Samurai Drive Shaft Spacers
« Reply #4 on: June 21, 2011, 11:07:57 AM »
k.  I just didn't know the "tell tell signs" that I need or don't need one.

1.5" will be my benchmark figure to look for
Logged
Ignorant questions lead to a wealth of knowledge
Pages: [1]   Go Up
« previous next »