my RPM that is ..... I changed my 02 sensor and now i have done the cold start pellet block and tightened up my exhaust for no leak ...now the truck is running great and sounds really good but I still am running at 1200-1300 rpm it does not go up and down or anything but it just sits there ......is there an idle adjust on these thing or should I look at something else...the throttle cable is not tight and the air filter is clean...I sprayed the vacuum lines with wd40 looking for leaks and no change at all. I cleaned up the plugs but did not do a great job of it. is there a TPS on these g16a motors? and if so where is it?

any suggestions would be helpful oh yeah I even checked the tire pressures????hahahaha

There is a TPS and an idle adjust too. If you haven't already done it download an FSM from
http://www.suzukiinfo.com
You probably need an analogue multimeter, IIRC you need to set the idle speed so that the Idle Speed Controller is at 50% duty cycle.

wow that was really technical. IIRC? what is that.

so there is no idle screw huh?