I would like to know if anybody had any luck on elminating the slip yoke inside the trac/kick t-cases I have a 89 tin top and I am putting toy axles in it with leafs.I know you can go to ott to get there kicker 2 setup to run a toy t-case behind yours but I would be looking close to a grand for this set up. any help would be great.I have the lower t-case gears already and mine is a two door.That's why I would like to stay with a single t-case to cut down on the drive angle in the back.If you have any pictures can you e-mail me them at pat.courchesne|removethispart|@sympatico.ca   thanks you in advance

 ihave done it on a tracker i built its not to difficult with the right equip.    stan

how did you make it stan and is it holding up

i machined out the shaft & threaded it so i could bolt on the yolk.  it's working great.         stan

i drilled and tapped the output shafts front and rear and made custom flanges that welded on to my stock slip yokes