Hello Guest
« previous next »
Pages: [1]   Go Down

Bracket Question

  • 5 Replies
  • 1687 Views

0 Members and 1 Guest are viewing this topic.

*

Online RJkick

  • 632
  • 5
  • Gender: Male
Bracket Question
« on: October 12, 2012, 10:06:13 AM »
After changing my head gasket I am down to this bracket.  I found a place to mount it back on to but it just doesn't look right. 

Can anyone let me know where this bracket goes?   Thanks
Logged
92 Sidekick 1.6L 16v Calmini\OME 4.5" lift 3" Body Lift OME962 springs in front w\.75" spacers OME955 in rear w\1.75" spacers Extreme Duty Strut Eliminator kit and rear ProComp MX6 Shocks 31X10.50 Nexen M\T   Thorley Header   2" exhaust  Calmini front truss bar and stabilizer and skids   Custom Bumpers and Rock Rails  Limit Straps
*

Offline mrfuelish

  • *
  • 2862
  • 13
  • Gender: Male
  • you must have a perception problem.
Re: Bracket Question
« Reply #1 on: October 12, 2012, 10:30:39 AM »
it's kind of hard to see it, could you take the bracket back off and take a better pic of it?
Logged
1987,1988,1988,1990 samurai's,  1953 m38a1,  1996 x-90,blue.1996 x-90 red.1994 2 door tracker.   only Dead Fish go with the flow.                No Hairy Nosed Wombats were ran over on the trail today.       My ZUK is Xenophobic.
*

Offline talonxracer

  • 1284
  • 34
Re: Bracket Question
« Reply #2 on: October 12, 2012, 11:14:38 AM »
Here is the best pic I have,


It looks like you have it upside down.
« Last Edit: October 12, 2012, 11:18:11 AM by talonxracer »
Logged
Tim "the toolman" Taylor is my HERO !!!

The only GOOD Commie is the commie taking a dirt nap....
*

Offline bentparts

  • *
  • 4536
  • 60
  • Gender: Male
  • I'd rather be Blown AND Injected.
    • mikekallie's flickr photos
Re: Bracket Question
« Reply #3 on: October 13, 2012, 04:35:44 AM »
Quote from: rjkick on October 12, 2012, 10:06:13 AM
After changing my head gasket I am down to this bracket.  I found a place to mount it back on to but it just doesn't look right. 

Can anyone let me know where this bracket goes?   Thanks

That' right and there should be a plastic cover that attaches to that bracket with three small bolts, two on that bracket and one on the throttle body housing.  I don't think that bracket can be mounted upside down, wouldn't fit.
Logged
The usual stuff, and 2nd generation Air to liquid intercooled TURBOCHARGER
*

Offline talonxracer

  • 1284
  • 34
Re: Bracket Question
« Reply #4 on: October 13, 2012, 05:59:15 AM »
Quote from: bentparts on October 13, 2012, 04:35:44 AM
Quote from: rjkick on October 12, 2012, 10:06:13 AM
After changing my head gasket I am down to this bracket.  I found a place to mount it back on to but it just doesn't look right. 

Can anyone let me know where this bracket goes?   Thanks

That' right and there should be a plastic cover that attaches to that bracket with three small bolts, two on that bracket and one on the throttle body housing.  I don't think that bracket can be mounted upside down, wouldn't fit.

Yes it is installed upside down, the two holes for mounting the plastic cover should be to the top of the bracket, not the bottom. I'll take a pic in a hour or so when it warms up a bit and I get outside and remove that cover on my kick.
Logged
Tim "the toolman" Taylor is my HERO !!!

The only GOOD Commie is the commie taking a dirt nap....
*

Online RJkick

  • 632
  • 5
  • Gender: Male
Re: Bracket Question
« Reply #5 on: October 14, 2012, 08:07:37 AM »
Yep, I had it upside down.  Nothing mounted top the top of it though.  I think the Zuk lost the plastic piece somewhere between 92 and 2005 when I tokk it over

Thanks

As usual the collective knowledge of the board knows all


Now I am going to try timing er and hopefully get er back on and off the road
Logged
92 Sidekick 1.6L 16v Calmini\OME 4.5" lift 3" Body Lift OME962 springs in front w\.75" spacers OME955 in rear w\1.75" spacers Extreme Duty Strut Eliminator kit and rear ProComp MX6 Shocks 31X10.50 Nexen M\T   Thorley Header   2" exhaust  Calmini front truss bar and stabilizer and skids   Custom Bumpers and Rock Rails  Limit Straps
Pages: [1]   Go Up
« previous next »